Favorite driver's magazines

"Fast Bikes", April 1, 2013



If your bike doesn’t have a slipper-clutch, go get one!

A slipper clutch is simply a mechanical device that, when activated, automatically separates the clutch plates. When you downshift the engine’s revs increase due to the lower gear. At this point, because the engine isn’t under power, the rear wheel attempts to turn the motor, which can be a bad thing and is called back-torque. Under power the motor has a rev limiter to stop it getting over revved and in turn damaging its internals. However, when the rear wheel is turning the motor there is no rev limiter – which is where the slipper clutch comes in. Inside a slipper clutch is a centre piece that lifts up on a series of ramps. These ramps lock in one direction (when the engine is turning the rear wheel) but not in the other and so when the back-torque is too much the clutch’s centre piece lifts and releases some of the pressure on the clutch plates – effectively pulling in the clutch lever. When the pressure reduces the centre piece drops down, reengaging the clutch at a set rate until the back-torque is once again too high. On track, they’re a wise investment.

Welcome to BrowseMags.com

Welcome to browsemags.com, a place where you can find a great selection of most popular driver’s magazines.

The website is dedicated to those who love driving fast cars and bikes.

All the content is submitted by our readers. Feel free to send us your favorite magazines.